Task 8: Boot The Rac - Bay Networks 5399 Quick Start Manual

Remote access concentrators

Hide thumbs Also See for 5399:

Table of Contents

Quick-Start Guide for Remote Access Concentrators

118352-A Rev. A

Save the changes you made to the RAC:

a) For the 5399 RAC, exit the ROM monitor by entering

Ctrl T. This brings you back to the System 5000 Slot

Selection Menu.

b) Enter s to select the supervisory Module main menu.

c) Enter m to select Module Information Menu.

d) At the Enter slot # (1-14): prompt enter the slot number

and press Return. Then type d to set all the changes you

made as the default.

Enable the allow_snmp_sets Parameter

If you plan to use Annex Manager or Quick2Conﬁg to conﬁgure and

manage the RAC, you must enable the allow_snmp_sets parameter. To

enable this parameter:

At the console monitor prompt, enter allow_snmp_sets.

Enter Y when you are asked if you want to enable this

parameter.

Task 8: Boot the RAC

Issue the boot command to boot the RAC. After the RAC boots, choose

which tools you want to use to complete the remaining conﬁguration

tasks. The remaining tasks in this book use admin commands from the

console monitor, but you can also use na, Annex Manager, or

Quick2Conﬁg.

Table of Contents

8000