Setting Ip Parameters Using Ip.cfg File On A Usb Memory Device; Nortel Ethernet Routing Switch 4500 Series; Installation Guide; Nn47205-300 (322811-B) 03.01 Standard - Nortel 4524GT Installation Manual

50 Installing the Nortel Ethernet Routing Switch
6
7
ip address parameters
Parameter
[stack | switch]
<ip_address>
<subnet_mask>
<gateway_address>
The IP configuration is now complete.
To continue configuration, use the appropriate CLI commands.
To disconnect from the switch, use the logout command.
Setting IP parameters using IP.CFG file on a USB memory device
If the swtich does not obtain an IP address using bootp, and, a file named
IP.CFG exists on the USB memory device, then the switch loads the IP.CFG
file as its configuration.
See also
Following table is an example of IP.CFG file.
IP.CFG file
Parameter
IP <xx.xx.xx.xx>
Mask <xx.xx.xx.xx>
Copyright © 2007, Nortel Networks
.
At the prompt, enter the configure terminal command.
At the prompt, enter the ip address command to set the switch
or stack IP address.
Following is the ip address command syntax:
ip address [stack | switch} <ip address> [netmak
<subnet mask>] [default-gateway <gateway address>]
The following table describes the ip address command
parameters.
Description
Use either the stack or switch key word to set the
appropriate IP address.
The IP address to be used.
The subnet mask to be used.
The default gateway address to be used.
"Universal Serial Bus (USB) ports" (page 35)
Description
Specifies the IP address for the switch.
Example: 192.168.22.1
Specifies the network mask.
Example: 255.255.255.0

Nortel Ethernet Routing Switch 4500 Series

Installation Guide

NN47205-300 (322811-B) 03.01 Standard

5.1 19 November 2007
—End—