Nortel 2350 Quick Start Manual page 34

34
Table 10: AP Identifier fields
Field
Name
AP Number
Serial Number
Fingerprint
4
5
6
7
8
Deploying the configuration
The entire configuration done so far is kept locally on the WMS server. To complete the switch configuration, all
local changes must be deployed to the WSS and saved.
Complete the following steps to deploy the configuration:
Step
1
NN47250-300 (320655-E Version 02.01)
• For a distributed AP, the AP Identifier screen appears. Complete the AP
Identifier fields, as described in
Description
Specifies a unique name for the AP.
Specifies the unique key for the AP.
Specifies the serial number of the AP.
The serial number and fingerprint of an AP are printed on the bottom of
the Access Point.
Specifies the fingerprint of the AP.
The serial number and fingerprint of an AP are printed on the bottom of
the Access Point.
Click Next.
The AP Type screen appears.
Select the correct AP Model from the list, and specify the AP Radio Type.
Click Next.
Depending on the radio type selected previously, either the 802.11g Radio or the
802.11a Radio screen appears. Check to ensure the Enabled checkbox is selected
before continuing.
Click Next.
The 802.11a Radio screen appears. Check to ensure the Enabled checkbox is
selected before continuing.
Click Finish.
Note: You cannot deploy Local Changes if Network Changes also exist.
This occurs when network changes are made directly to the WSS using the
local interface in the interim. Review any Network Changes before deciding
if you want to Accept or Undo them, before deploying Local Changes.
Action
Select WSS_model from the navigation tree.
Table 10.
End