Anti-Theft Alarm (Dwa) - BMW S 1000 RR 2021 Rider's Manual

74 OPERATION

ANTI-THEFT ALARM (DWA)

with anti-theft alarm (DWA)
Activation
Switch on the ignition (
Customising anti-theft alarm
settings (
Switch off the ignition.
If the alarm system is activ-
ated, then the alarm system
will be automatically activated
when the ignition is switched
off.
Activation takes approximately
30 seconds to complete.
Turn indicators flash twice.
Confirmation tone sounds
twice (if programmed).
Anti-theft alarm is active.
Alarm signal
A DWA alarm can be triggered
by:
motion sensor
switch-on attempt with an
unauthorised vehicle key.
disconnection of the DWA
anti-theft alarm from the mo-
torcycle's battery (DWA in-
ternal battery in the anti-theft
alarm provides power - alarm
tone only, the turn indicators
do not flash)
75).
All functions are sustained even
if the internal battery of the
OE
DWA anti-theft alarm system is
flat; the only difference is that
58).
an alarm cannot be triggered
if the system is disconnected
from the motorcycle's battery.
An alarm lasts for approxim-
ately 26 seconds. While an
alarm is in progress an alarm
tone sounds and the turn
indicators flash. The type of
alarm tone can be set by an
authorised BMW Motorrad
dealer.
If an alarm was triggered while
the motorcycle was unatten-
ded, the rider is notified ac-
cordingly by an alarm tone
sounding once when the igni-
tion is switched on. The DWA
LED then indicates the reason
for the alarm for one minute.
Light signals issued by the
DWA LED:
Flashes 1x: motion sensor 1
Flashes 2x: motion sensor 2
Flashes 3x: ignition switched
on with unauthorised vehicle
key
Flashes 4x: disconnection of
the anti-theft alarm from the
motorcycle's battery
Flashes 5x: motion sensor 3