English
[1-20] Viewing window/chip guard
[1-21] Feeler wedge
[1-22] Protective lid
5.2
Scoring unit
[1-23] Button for the scoring unit spindle
stop
[1-24] Adjusting wheel for cutting width/
cutting depth of scoring unit
[1-25] Adjusting wheel for lateral offset of
the scoring unit
[1-26] Lever for activating/deactivating the
scoring unit
The illustrations specified are located at the be
ginning and end of the operating instructions.
Accessories shown or described are not always
included in the scope of delivery.
6
Commissioning
WARNING
Unauthorised voltage or frequency.
Risk of accidents
► The mains voltage and the frequency of the
power source must correspond to the
specifications on the name plate.
► In North America, only Festool machines
with the voltage specifications 120 V / 60 Hz
may be used.
Always switch off the machine before
connecting and disconnecting the mains
power cable.
Only use guide rails with a splinter guard that
has been cut into using this machine (see sec
tion 12.2).
The scoring unit is not aligned with the
main saw blade when delivered. Adjust the
scoring unit before using it for the first
time (see section 8, in the order 8.4/ 8.5).
6.1
Machines with plug-it connection
Applies to TSV 60 KEBQ.
28
CAUTION
Heating of the plug it connection if bayonet
fitting is not completely locked
Risk of burns
► Before switching on the power tool, make
sure that the bayonet fitting at the mains
cable is closed fully and locked.
Connecting and detaching the mains power ca
ble [1-12] see Fig. [2].
7
Main unit settings
WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
7.1
Electronics
Speed control
You can continuously adjust the speed within
the speed range using the adjusting wheel [1-2]
(see "Technical data"). This enables you to opti
mise the cutting speed to suit each surface.
Speed range per material
Solid wood (hard, soft)
Chipboard and hardboard
Laminated wood, blockboard, veneered
and laminated panels
Laminate, mineral materials
Plaster- and cement-bonded chipboard
and fibreboard
Aluminium panels and profiles up to
15 mm
Plastics, fibre-reinforced plastics, paper
and fabric
Acrylic glass
Overload protection
Electronic overload protection protects the mo
tor from damage if there is an extreme over
load. In this case, the motor remains at a stand
still and only starts up again once the load has
been removed. To restart the machine, you
must switch it on again.
Brake
The saw comes with an electronic brake. The
saw blade is stopped electronically within ap
6
3–6
6
4–6
1–3
4–6
3–5
4–5