Commissioning; Battery Pack - Festool CSC SYS 50 EBI Original Instructions Manual

English
[2-15] Bluetooth® connection status (if
Bluetooth® function is active)
[2-16] Favourite assignment (main screen)
7

Commissioning

7.1 Setting up the power tool
WARNING
Risk of accidents
Power tool tips over on uneven surface.
► Ensure that the power tool is securely
positioned. The surface underneath the
machine must be level, in good condition
and free of loose objects (e.g. chips and
offcuts).
► Position the power tool on a level and firm
surface and use the rubber feet to ensure
that it is horizontal and level.
► Loosen the locking clips [1-22] on both
sides of the power tool.
► Lift the Systainer hood [1-23] upwards to
remove it.
7.2 Initial commissioning
The following sequence will start on the display
after switching on the power tool for the first
time:
1. Language and unit settings.
2. The "Initial steps" assistant explains the
basic operation of the power tool.
3. The initial reference movement is carried
out.
4. Calibrate the cutting height to zero (see
section 9.5).
5. The main screen (cutting angle/cutting
height) is displayed.
If the reference movement is interrupted, it is
requested again the next time the power tool is
switched on.
7.3 Switching on/off
Switching on the power tool
► Insert the battery packs (see Section 8).
► Press the main switch [1-3].
The LED [1-4] lights up. If a reference move­
ment is required, this will be indicated on the
display.
► Carry out the reference movement: Press
and hold the dial [2-4].
32
In order to achieve permanently precise
working results, we recommend carrying
out a Reference movement after trans­
porting the power tool.
Switching on the saw blade
► Make the required settings on the control
module (see section 9.1).
► Position the workpiece and, if necessary,
secure it in the groove [1-8] on the sliding
table using a Festool guide rail clamp.
► Keep hands away from the saw area.
► Press the start switch [2-5].
The saw blade starts.
Switching off the saw blade
► To switch off sawing mode, press the stop
switch [2-6].
If the saw blade continues to rotate: Use
the main switch [1-3] to switch off the
power tool or remove the battery pack.
Contact Festool Service.
Switching off the power tool
► Wait until the saw blade has come to a stop.
► Use the main switch [1-3] to switch off the
power tool.
After not being operated for four hours,
the power tool switches off completely.
(The time can be changed via the
Festool Work app.)
8

Battery pack

Before using the battery pack, check that the
battery interface is clean. Any contamination of
the battery interface may impair correct contact
and lead to the contacts being damaged.
A faulty contact may result in the machine over­
heating or being damaged.
[3A] Remove the battery pack.
[3B]
Insert the battery pack – until it
clicks into place.
The power tool can only be operated when
both battery packs are inserted and have a
sufficiently high charging capacity. See
section 4 for suitable battery packs.
8.1 Capacity indicator
The charge level of the battery packs is shown
on the display and in the Festool Work app. The
numbering of the battery packs [3B-1] can be
found next to the battery interfaces.