Commissioning; Machine Settings - Festool PRECISIO CS 70 EB Original Operating Manual

5.3 Other risks
In spite of compliance with all relevant design
regulations, dangers may still present them-
selves when the machine is operated, e.g.:
- workpiece parts being thrown off,
- parts of damaged tools being thrown off,
- noise emissions,
- wood dust emissions.
6

Commissioning

WARNING
Risk of accident if the machine is operated us-
ing unauthorised voltages or frequencies.
fThe mains voltage and the frequency of the
power source must correspond with the
specifications on the machine's name plate.
6.1 Assembling the machine
Setting up the machine
Ensure that the floor around the machine is level,
in good condition and free of loose objects (e.g.
chips and offcuts).
L
The machine can be set up with or without
the legs unfolded. To unfold the legs:
fUnscrew the rotary knobs [1-12] all the way.
fUnfold the legs [1-1] and tighten the rotary
knobs [1-12] again.
If the machine wobbles, turn the end cap [1-9] on
one leg to adjust the length so that the machine
stands securely.
Fitting the knob
fScrew the rotary knob [2-6] supplied anti-
clockwise into the guide rod.
Fitting the guard
fPull the spacer wedge [1-6] sharply upwards
[7-2] to move to the top catch position.
fSecure the upper guard supplied to the spacer
wedge in this position using the rotary knob
[1-11].
Transport
fEngage the saw unit in the zero position.
fRemove all attachments from your saw and
wind up the cable on the cable holder.
fFold up the legs.
6.2 On/Off switch
L
We recommend using a 16 A fuse because of
the performance of the motor.
fTo switch on: Press the green "On" switch
[1-2]. The red button is the "Off" switch.
L
A switch-on lock is available as an accessory
to prevent the machine from switching on
unintentionally.
7

Machine settings

WARNING
Risk of accident, electric shock
fAlways pull the plug out of the socket before
performing any type of work on the machine.
7.1 Electronics
The machine features full-wave electronics with
the following properties:
Smooth start-up
The electronically controlled smooth start-up
function ensures that the machine starts up
smoothly.
Speed control
You can regulate the rotational speed (CS 70 EB
only) steplessly between 2000 and 4200 rpm us-
ing the adjusting wheel [2-1]. This enables you to
optimise the cutting speed to suit the respective
material.
only CS 70 EB
# n [rpm]
0
1 ~ 2000
2 ~ 2400
3 ~ 2800
The preselected motor speed remains constant
through electronic control. This ensures a uni-
form cutting speed even when under strain.
Overload safety device
The machine power supply is limited if the ma-
chine is overloaded to extremes. The power sup-
ply is interrupted permanently if the motor is
blocked for a few moments. Switch the machine
off and on again to reset.
Temperature cut-out
The machine power supply is limited and the
speed reduced if the motor exceeds a certain
temperature. The machine continues operating
at reduced power to allow the ventilator to cool
P R E C I S I O
# n [rpm]
0
4 ~ 3300
5 ~ 3800
6 ~ 4200
17