Safety Recommendations - H3C S5130S-10P-EI Manual

Model
S5130S-28S-UPWR-EI-Q
S5130S-52S-PWR-EI
S5130S-52P-PWR-EI-AC
S5130S-52S-PWR-EI-AC
S5130S-28P-HPWR-EI-AC
S5130S-28S-HPWR-EI-AC
S5130S-28MP-HPWR-EI
S5130S-10MS-UPWR-EI
S5130S-28ST-PWR-EI
S5130S-52ST-PWR-EI
NOTE:
Switches of the same model but different PIDs might differ in hardware and software features. You
can view the PID of a switch on the label located on its cover.

Safety recommendations

To avoid equipment damage or bodily injury, read the following safety recommendations before
installation. Note that the recommendations do not cover every possible hazardous condition.
•
Before cleaning the switch, remove all power cords from the switch. Do not clean the switch
with wet cloth or liquid.
•
Do not place the switch near water or in a damp environment. Prevent water or moisture from
entering the switch chassis.
•
Do not place the switch on an unstable case or desk.
•
Ensure good ventilation at the installation site and keep the air inlet and outlet vents of the
switch free of obstruction.
•
Connect the yellow-green protection grounding cable before power-on.
•
Make sure the power source voltage is as required.
•
To avoid electrical shocks, do not open the chassis while the switch is operating or when the
switch is just powered off.
•
When you install the switch, or install or remove modules, wear an ESD wrist strap and make
sure it makes good skin contact and is reliably grounded.
Product code (PID)
LS-5130S-28S-UPWR-EI-Q
LS-5130S-52S-PWR-EI
LS-5130S-52S-PWR-EI-GL
LS-5130S-52P-PWR-EI-AC
LS-5130S-52P-PWR-EI-AC-GL
LS-5130S-52S-PWR-EI-AC
LS-5130S-52S-PWR-EI-AC-GL
LS-5130S-28P-HPWR-EI-AC
LS-5130S-28P-HPWR-EI-AC-GL
LS-5130S-28S-HPWR-EI-AC
LS-5130S-28S-HPWR-EI-AC-GL
LS-5130S-28MP-HPWR-EI
LS-5130S-28MP-HPWR-EI-GL
LS-5130S-10MS-UPWR-EI
LS-5130S-10MS-UPWR-EI-GL
LS-5130S-28ST-PWR-EI
LS-5130S-28ST-PWR-EI-GL
LS-5130S-52ST-PWR-EI
LS-5130S-52ST-PWR-EI-GL
1-3