Siemens SIMOVERT FC Operating Instructions Manual page 9

12.96
5. Electrical connection
When working on live drive converters, the applicable national accident prevention rules (e.g. VBG 4) must be
complied with.
The electrical installation shall be carried out in accordance with the relevant requirements (e.g. cross-sectional
areas of conductors, fusing, PE connection). For further information, see documentation.
Instructions for the installation in accordance with EMC requirements, like screening, earthing, location of filters
and wiring, are contained in the drive converter documentation. They must always be complied with, also for
drive converters bearing a CE marking. Observance of the limit values required by EMC law is the
responsibility of the manufacturer of the installation or machine.
6. Operation
Installations which include drive converters shall be equipped with additional control and protective devices in
accordance with the relevant applicable safety requirements, e.g. Act respecting technical equipment, accident
prevention rules etc. Changes to the drive converters by means of the operating software are admissible.
After disconnection of the drive converter from the voltage supply, live appliance parts and power terminals
must not be touched immediately because of possibly energized capacitors. In this respect, the corresponding
signs and markings on the drive converter must be respected.
During operation, all covers and doors shall be kept closed.
7. Maintenance and servicing
The manufacturer's documentation shall be followed.
Keep safety instructions in a safe place!
Siemens AG 6SE7087-6AH70
SIMOVERT MASTER DRIVES Operating Instructions
General
0-9