Siemens SIMOVERT FC Operating Instructions Manual page 7

12.96
CAUTION
Components which can be destroyed by electrostatic discharge (ESD)
The converters contain components which can be destroyed by electrostatic discharge. These components can
be easily destroyed if not carefully handled. If you have to handle electronic boards please observe the
following:
♦ Electronic boards should only be touched when absolutely necessary.
♦ The human body must be electrically discharged before touching an electronic board
♦ Boards must not come into contact with highly insulating materials - e.g. plastic foils, insulated desktops,
articles of clothing manufactured from man-made fibers
♦ Boards must only be placed on conductive surfaces
♦ When soldering, the soldering iron tip must be grounded
♦ Boards and components should only be stored and transported in conductive packaging (e.g. metalized
plastic boxes, metal containers)
♦ If the packing material is not conductive, the boards must be wrapped with a conductive packaging material,
e.g. conductive foam rubber or household aluminum foil.
The necessary ECB protective measures are clearly shown in the following diagram:
a = Conductive floor surface
b = ESD table
c = ESD shoes
d
b
e
c
a
Sitting
Hazardous voltages are present in this electrical equipment during operation.
Non-observance of the safety instructions can result in severe personal injury or property
damage.
Only qualified personnel should work on or around the equipment after first becoming
thoroughly familiar with all warning and safety notices and maintenance procedures
contained herein.
The successful and safe operation of this equipment is dependent on proper handling,
installation, operation and maintenance.
Siemens AG 6SE7087-6AH70
SIMOVERT MASTER DRIVES
d
f
f
c
Standing
Operating Instructions
d = ESD overall
e = ESD chain
f = Cubicle ground connection
f f
a
Standing / Siting
WARNING
d
b
e
f
c
a
General
0-7