Moving The Network Card To A Different Slot - NETGEAR GA622T Reference Manual

Copper gigabit ethernet card

Hide thumbs Also See for GA622T:

Table of Contents

Table 3-1. Parameter Descriptions (continued)

Property

Pause Frames Count

Pause Frames High Threshold IEEE 802.3x flow control settings help fine-tune network performance by

Pause Frames Low Threshold IEEE 802.3x flow control settings help fine-tune network performance

Receive Buffer Count

Transmit Buffer Count

Moving the Network Card to a Different Slot

Windows 98 automatically detects the installation and removal of hardware.To move

a GA622T Copper Gigabit Ethernet Card to a different slot in the same system:

1. Shut down the system and remove the card from the PCI slot.

2. Install the card in its new PCI slot (see "Installing Your Copper Gigabit Ethernet

Card" on page 2-7).

3. When the system is powered on, reinstall the driver software (see "Installing the

Driver Software" on page 3-1).

Description

IEEE 802.3x flow control settings help fine-tune network performance by

preventing dropped packets.

by preventing dropped packets.

Specifies hardware resources in memory used to receive packets.

Specifies hardware resources in memory used to send packets.

Increasing this value may increase transmit performance.

Windows 95OSR2/98/Me driver software

3-7

Table of Contents