Table of Contents
Advertisement
gateways_12_hg3575v4.fm
HiPath Gateway HG 3575 V4 - Changing Parameters with AMO STMIB
TYPE H323 - Changing the H323 Settings at the Access Point
12.8 TYPE H323 - Changing the H323 Settings at the Access Point
12.9 TYPE JB - Configuring the Jitter Buffer
112
Configuration Management --> System Data --> IPDA --> IPDA System
Data
Click Search and select the access point. Click Execute on the Action
pull-down menu and select the mode of action Update AP, confirm with
OK.
EXEC-USSU:MODE=UPDATAP,LTU=99;
IMPORTANT: Connections are cleared down without further warning.
Prior to the EXEC-USSU:UPDATAP, the configuration must be updated on the
system hard disk.
Direct media connections use the H323 fast connect mechanism to set up
connections. The NCUI2/4 and STMI2/4 platform consequently supports H.323.
Two timers from the H.323 stack and the gateway name can be modified.
Configuration Management --> System Data --> IPDA --> IPDA Access
Point
Click Search and select the access point.
Enter under Direct Media Connection (DMC) enabled on the General tab
and Save.
CHANGE-STMIB:MTYPE=NCUI2,LTU=99,TYPE=H323,Q931T1=50,
Q931T2=500,GWNAME="HG3575-2";
This change is started directly on the access point and is effective immediately
with the next H.323.
As of HiPath 4000 V4, only the adaptive jitter buffer (JBMODE=2) and the static
jitter buffer (JBMODE=1) are supported in the HG 3575 V4 gateway. If
JBMODE=0 (LEGACY MODE) is set in the AMO STMIB, this is mapped to the
static jitter buffer (JBMODE=1) in the gateway.
A basic understanding of procedures and configuration parameters is required to
perform configuration. Refer to
The adaptive jitter buffer (JBMODE=2) that reduces delays is set by default.
HiPath 4000 V5, IP Solutions - HG 3500 & HG 3575, Service Documentation
Section 2.5, "Jitter
Buffer".
A31003-H3150-S104-2-7620, 03/2009
Advertisement
Table of Contents
