Type Asc - Changing The Payload Qos Setting Of The Access Point - Siemens HG 3500 V4 Service Manual

12.4 TYPE ASC - Changing the Payload QoS Setting of the Access Point

A31003-H3150-S104-2-7620, 03/2009
HiPath 4000 V5, IP Solutions - HG 3500 & HG 3575, Service Documentation
HiPath Gateway HG 3575 V4 - Changing Parameters with AMO STMIB
TYPE ASC - Changing the Payload QoS Setting of the Access Point
CHANGE-STMIB:MTYPE=NCUI2,LTU=17,TYPE=SERVIF,
LOGINTRM=TERMINAL,LOGINPPP=SURV,PASSW2=HG3575;
This change does not become effective until the access point is restarted.
Configuration Management --> System Data --> IPDA --> IPDA System
Data
Click Search and select the access point. Click Execute on the Action
pull-down menu and select the mode of action Update AP, confirm with
OK.
EXEC-USSU:MODE=UPDATAP,LTU=17;
IMPORTANT: Connections are cleared down without further warning.
Prior to the EXEC-USSU:UPDATAP, the configuration must be updated on the
system hard disk.
<LW-version>
<LW-version> holds the currently loaded loadware version number (e.g. L0-
TOS.10.030-004)
In this branch, the Quality of Service for the payload of an access point can be
configured. The settings can differ from access point to access point. If the
routers do not support DiffServ, the standard TOS value must be configured
without DiffServ. If DiffServ is supported, but not the Siemens CodePoints, the
value specified by the network operator must be configured.
In the example, the standard TOS value is set for AP 99 without DiffServ (see also
Table 2, "TOS values").
Configuration Management --> System Data --> IPDA --> IPDA Access
Point
Click Search and select the access point.
Enter the TOS bytes under Layer 3-Diffserv on the Quality of Service tab
and Save.
CHANGE-STMIB:MTYPE=NCUI2,LTU=99,TYPE=ASC,TOSPL=16;
This change is started directly on the access point and is effective immediately
without an interruption in operation.
gateways_12_hg3575v4.fm
109