Table of Contents
Advertisement
11 DLS Client Bootstrapping
11.1 Bootstrapping with "No PIN" PIN Mode
11.2 Bootstrapping with "Default PIN" or "Individual PIN" PIN Mode
A31003-H3150-S104-2-7620, 03/2009
HiPath 4000 V5, IP Solutions - HG 3500 & HG 3575, Service Documentation
DLS client bootstrapping is a procedure that must be performed once to allow the
DLS server to exchange configuration data with the gateway. This procedure
generates an individual (DLS) certificate for the gateway and transfers it to the
gateway. The gateway and DLS can then use these certificates for unique
reciprocal authentication.
Variant A:
1. Create a virtual IP device in the DLS under IP Devices > IP Device
Management > IP Device Configuration.
2. Contact the gateway in DLS via IP Devices > IP Device Interaction > Scan
IP Devices. Enter 8084 in the Port field in the "IP Ranges" tab.
If everything is in order, the value Secure appears in the Security Status: field
in the DLS under IP Devices > IP Device Management > IP Device
Configuration > "DLS Connectivity" tab.
Variant B:
1. Create a virtual IP device in the DLS under IP Devices > IP Device
Management > IP Device Configuration.
2. Enter the IP address of the DLS server at the gateway with the CLI command
set dls ip_address. The port is usually 18443.
3. Enter the CLI command contact DLS at the gateway.
Variant A:
1. Create a virtual IP device in the DLS under IP Devices > IP Device
Management > IP Device Configuration > "DLS Connectivity" tab and
then select the required PIN mode.
2. Contact the gateway in DLS via IP Devices > IP Device Interaction > Scan
IP Devices. Enter 8084 in the Port field in the "IP Ranges" tab.
3. Enter the CLI command activate dls pin <pin> at the gateway with
the PIN displayed under 1.
gateways_11_dls_client_bootstrapping.fm
DLS Client Bootstrapping
Bootstrapping with "No PIN" PIN Mode
103
Advertisement
Table of Contents
