Adjusting The Position Of The Finisher - Minolta Di450 Service Manual

Hide thumbs Also See for Di450:

Table of Contents

Adjusting the Position of the Finisher

Di450 / Di550

5. Fit the other end of the Pipe into the mounting

guide on the Finisher Tray side and insert the

Pipe until a click is heard.

At this time, do not press the Finisher up against

the machine, yet.

When Removing the Pipe

Using the tabs on the Finisher side, unlock the

Pipe and pull it out from the mounting guide.

Then, remove the Pipe together with the Feeder

Attachment installed in step 3. Next, pull the Pipe

out of the Feeder Attachment.

1. Slowly move the Finisher toward the machine

and check the followings:

Alignment between the Positioning Pin and

the hole in the Finisher (height) (in the rear)

Alignment between Fixing Bracket A and the

fixing bracket on the Finisher (height) (at the

If the parts are not properly aligned with each

other, perform these steps to make an

2. Remove the Lower Front Cover (two screws)

of the Finisher.

Rev. 1.1/10.00

Table of Contents