Adjusting The Height Of The Finisher - Minolta Di251 Service Manual

Packing material
1.10.6

Adjusting the height of the Finisher

OK
Adjust bolt
Rev. 11..0.0/03.01
Do not secure the Horizontal Transport Unit with
the lock lever at this time yet. Also, do not
remove the packing material from the coupling
gear of the Finisher at this time.
5. Positively engage the gears on the horizontal
transport unit with those on the Finisher as
illustrated. Then, secure the horizontal
transport unit in position with the lock lever
and remove the packing material from the
coupling gear of the Finisher.
1. Separate the Finisher from the copier.
2. Check to make sure that the horizontal
transport unit is not leaning.
If the horizontal transport unit appears to be
leaning, use the following procedure to adjust
the standing position of the unit.
3. Loosen the front and back wing bolts (2)
located on the right side of the Finisher and
use the adjust bolt to adjust the height.
If the horizontal transport unit appears lower
toward the Finisher, turn the adjust bolt
clockwise.
If the horizontal transport unit appears lower
Wing bolts
toward the copier, turn the adjust bolt
counterclockwise.
4. After the height has been adjusted, tighten
the front and back wing bolts (2) and set the
adjust bolts.
I-63
NOTE
Di251/Di351