Adjusting The Position Of The 2Nd Folding Stopper (Zk-2 Only) - Minolta Di551 Service Manual

[35] Adjusting the Position of the 2nd
Folding Stopper (ZK-2 only)
Note: This adjustment affects the 2nd folding
skew. Therefore, first complete this
adjustment and then proceed to the [15]
Adjusting the 2nd Folding Skew section.
1. Tools
• Screwdriver (Phillips)
• Hex wrench
2. Adjustment Method
1
2
4
6
A= 20 ± 0.5 mm
1. Hex screw
2. Pulley
3. Shaft
4. 2nd foldng stopper
5. Paper stopper
6. Guide plate
1
2
3
4
5
2-143
Step Operation
Set paper into the tray and make a copy
(required to place the paper stopper at its
1
HP position).
Open the front door of the FNS and draw out
2
the conveyance unit.
Make sure that the distance between the
edge of the guide plate and the paper stop-
per is within the specification range.
Spec range: A = 20 ± 0.5 mm
3
If the distance is outside the spec range,
adjust according to the instructions
described in the following step.
Loosen the screws holding the pulleys and
adjust the distance by rotating the pulleys.
Tighten the screws.
Note: Do not rotate the shaft on which the
4
pulleys are attached. If it is rotated for some
reason, the stopper is placed out of its HP
position. Then perform the procedure again
from Step 1.
ADJUSTMENT