Fsm7328Ps Rear Panel; Fsm7352S Front Panel And Leds - NETGEAR ProSafe FSM7328PS Hardware Installation Manual

Managed Stackable Layer 3 Fast Ethernet Switches Hardware Installation Guide

FSM7328PS Rear Panel

The rear panel has a Console port, redundant power supply (RPS) connector, and a
standard AC power receptacle for the supplied power cord.
Console port
Console
RPS Connector
Figure 2-4

FSM7352S Front Panel and LEDs

The following figure shows the front panel of the FSM7352S. The front panel
contains LEDs, RJ-45 jacks, SFP module bays, and stacking ports.
LEDs
Figure 2-5
The following table shows the FSM7352S LEDs on the front of the switch.
Table 2-3. FSM7352S LED Description
LED
Master
Fan
2-6
Redundant power supply (RPS)
RJ-45 jacks
Description
Green on: The switch is the master of the stack.
Yellow on: The switch is not the master of the stack.
Off: The switch is not part of a stack.
Solid red: Fan has failed.
Off: Fan is present and operating normally.
v1.0, May 2007
Power receptacle
SFP module bays
100-240V~50-60Hz, 3.0A max.
Stacking ports
Introduction