Fsm7352Ps Front Panel And Leds - NETGEAR ProSafe FSM7328PS Hardware Installation Manual

Managed Stackable Layer 3 Fast Ethernet Switches Hardware Installation Guide

FSM7352PS Front Panel and LEDs

The following figure shows the front panel of the FSM7352PS. The front panel
contains LEDs, RJ-45 jacks, SFP module bays, and stacking ports. The console
port is on the rear panel.
FSM7352PS Front Panel
1
LEDs
Figure 2-7
The following table describes the FSM7352PS LEDs on the front of the switch.
Table 2-4. FSM7352S LED Description
LED
ID
Master
Fan
Power
MAX PoE
RPS (redundant
power supply)
2-8
RJ-45 jacks
Description
This is the stack member ID (1–8) that the software assigns to the
switch.
Green on: This switch is the master of the stack.
Off: The switch is not part of a stack.
Solid red: Fan has failed.
Off: Fan is present and operating normally.
Solid green: Power is supplied, and the switch is operating normally.
Solid yellow: Power-On Self-Test (POST) is in progress.
Blinking yellow: POST failure or CPU failure.
Off: Power is disconnected.
Solid yellow: Less than 15.4 W of PoE power is available.
Blinking yellow: The MAX PoE LED was active in the previous two
minutes.
Off: There is at least 7 W of PoE power available for another device.
Solid green: RPS bank supply PoE power.
Off: RPS bank is disconnected.
v1.0, May 2007
SFP Stacking
module ports
bays
Introduction