Fsm7328Ps Front Panel And Leds - NETGEAR ProSafe FSM7328PS Hardware Installation Manual

Managed Stackable Layer 3 Fast Ethernet Switches Hardware Installation Guide

FSM7328PS Front Panel and LEDs

The following figure shows the front panel of the FSM7328PS. The front panel
contains LEDs, RJ-45 jacks, SFP module bays, and stacking ports.
1
PoE L/A
ID
Master
BPS
Fan
PWR
MaxPoE
2
PoE:
RST Green=PoE Active Yellow=Poe Fault
L/A: Green=link at 100M Yellow+Link at 10M Blink=Activity
LEDs
Figure 2-3
The following table shows the LEDs on the front panel of the switch.
Table 2-2. LED Descriptions for FSM7328PS
LED
ID
Master
Power
Fan
MAX PoE
RPS (redundant
power supply)
2-4
5 7 9 11 13
3
8 10 14
4 6 12
RJ-45 jacks
Description
This is the stack member ID (1–8) that the software assigns to the
switch.
Green: This switch is the master of the stack.
Off: The switch is not the master of the stack.
Solid green: Power is supplied, and the switch is operating normally.
Blinking green: Runtime code load in progress.
Solid yellow: Power-On Self-Test (POST) in progress.
Blinking yellow: POST failure or CPU failure.
Off: Power is disconnected.
Solid red: Fan has failed.
Off: Fan is present and operating normally.
Solid yellow: Less than 15.4 W of PoE power is available.
Blinking yellow: The MAX PoE LED was active in the previous two
minutes.
Off: There is at least 7 W of PoE power available for another device.
Solid green: RPS bank supply PoE power.
Off: RPS bank is disconnected.
15 17 19 21 23
16 18 20
22 24
SFP module bays
v1.0, May 2007
Stack
Link/ACT
26 27
25
Stacking ports
28
Introduction