Fsm7328S Rear Panel - NETGEAR ProSafe FSM7328PS Hardware Installation Manual

Managed Stackable Layer 3 Fast Ethernet Switches Hardware Installation Guide
Table 2-1. LED Descriptions for FSM7328S (continued)
LED
10/100/1000M
ports
two LEDs per port
SFP port
(1000 Mbps only)

FSM7328S Rear Panel

The rear panel has a standard AC power receptacle for the supplied power cord.
Figure 2-2
Introduction
Description
Link/ACT LED
• Off: No 10/100/1000 Mbps link is established on the port.
• Solid green: A valid 1,000 Mbps link is established on the port.
• Solid yellow: A valid 10/100 Mbps link is established on the port.
• Blinking green: Packets transmission or reception is occurring on
the port at 1,000 Mbps.
• Blinking yellow: The port is sending or receiving packets at
10/100 Mbps.
Stack LED
• Green: Stack port has a valid link connection.
• OFF: Stack port does not have a valid link connection.
• Solid green: Link is up.
• Blinking green: The port is sending or receiving a packet in link up
status .
• Off: No link is detected .
v1.0, May 2007
Power receptacle
power
2-3