Jøtul F 500 ECO UKCA Installation And Operating Instructions Manual page 14

ENGLISH
Fig. 18b Removing of baffl e plates
2. The baffl e plates are now loose and can be edged out of
the stove. NB: Right plate fi rst, then left.
When refi tting, follow the same procedure in reverse order
(fi rst see fi g. 18c).
Fig. 18c Replace gasket on baffl e plate
3. When replacing the baffl e plate, the gasket against the
exhaust defl ector must also be replaced. This is done by
putting the included gaskets in grooves on the top of the
baffl e plate.
7.2 Replacing the exhaust defl ector
Fig. 19a Replacing the exhaust defl ector
1. Loosen the 2 screws on each side of the stove.
14
Fig. 19b Replacing the exhaust defl ector
2. Loosen the screw (A) that holds the top plate in place. This must
be done from the inside of the burnchamber.
Fig. 19c Replacing the exhaust defl ector
3. Lift the top, turn it 180 degrees and place it on a fl at underlay.
NB: It is important that the underlay is soft, so that the surface
is not damaged.
Fig. 19d Replacing the exhaust defl ector
4. Loose the 4 screws that secures the exhaust defl ector to the
top.
5. When refi tting, follow the same procedure in reverse order.
A