Fine Adjustment Of Scanning Position (Maintenance Mode 54); Fine Adjustment Of Scanning Position - Brother MFC-J2320 Service Manual

1.3.16 Fine Adjustment of Scanning Position (Maintenance mode 54)

< Function >
This function adjusts the scanning start and end positions.
< Operating Procedure >
(1) Press the 5 and 4 keys in this order in the initial stage of the maintenance mode.
Simplex scanning models: The "SCAN ADJ SELECT" appears on the LCD. Go to
step (3).
Duplex scanning models: The "0: FRONT 1: BACK" appears on the LCD.
(2) To adjust the first side scanning position, press the 0 key. The "SCAN START
ADJ." appears on the LCD.
To adjust the second side scanning position, press the 1 key. The "SCAN START
ADJ." appears on the LCD.
(3) To adjust the right and left edges, press the 0 key. The "RL EGDE **" appears on
the LCD.
To adjust the top edge, press the 1 key. The "TOP EGDE **" appears on the LCD.
To adjust the bottom edge, press the 2 key. The "BOTM EGDE **" appears on the
LCD.
(4) Enter the correction value (in units of 0.1 mm) multiplied by 10.
To increase the value by 10 (1.0 mm), press the
key. To increase the value by 1 (0.1 mm), press the
key.
Note: • Pressing the CLR key resets the correction value to 0.
• Pressing the X key returns the machine to the initial stage of the
maintenance mode without making changes of the correction value.
key; to decrease it, press the
5-32
key; to decrease it, press the
Confidential