Wiring Connection - Kenwood DMX7022S Instruction Manual

Installation and Connection Installation and Connection

Wiring connection

REMO-IN
10 A fuse
Purple with white stripe
Light green
]
White / White with black stripe
]
Gray / Gray with black stripe
]
Green / Green with black stripe
]
Purple / Purple with black stripe
Brown
Orange with white stripe
Light blue with yellow stripe
Blue with white stripe (12 V
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
AVM
Í
Steering
Remote
"
Connect the aerial cord to the aerial terminal
USB terminal (1 m)
(USB1)5V 1.5A
To the car's reverse lamp harness when using the optional rear view camera
REVERSE
PRK SW
[
To front speakers (left) / Mid-range speakers (left) for 3-way crossover
[
To front speakers (right) / Mid-range speakers (right) for 3-way crossover
[
To rear speakers (left) / Tweeters (left) for 3-way crossover
[
To rear speakers (right) / Tweeters (right) for 3-way crossover
(Not used for this unit)
MUTE
To the car light control switch
ILLUMI
STEERING WHEEL
REMOTO INPUT
To the steering wheel remote control adapter (not supplied)
REMOTE CONT
350 mA)
To the power control terminal when using the optional power amplifier (Or)
ANT.CONT
P.CONT
To the control terminal of the motor aerial or to the power terminal for the booster amplifier of film-type aerial
Gray/Red
ST REMOTE
Connect to your vehicle's
GND
Bright green/Red
steering remote harness.
Input 1
Contact your KENWOOD
Purple/Red
dealer for details.
Input 2
Connect a USB device
Extension wire ( ø )
To the car chassis
To the car's parking brake detection switch harness
(For best safety, be sure to connect the parking sensor.)
Ignition key switch
Car fuse
Car battery
ENGLISH 47