Installation And Connection - Kenwood DMX7022S Instruction Manual

Remote Controller Remote Controller
DVDSETUP Not used for this unit.
RETURN Not used for this unit.
AUDIO Not used for this unit.
SUBTITLE Not used for this unit.
ANGLE Not used for this unit.
ZOOM Not used for this unit.
OPEN Not used for this unit.
2 ZONE Not used for this unit.
Not used for this unit.
R.VOL
CLEAR Not used for this unit.
Audio file/Video file/Picture file
FM+ / AM− Selects a folder.
S / T Selects a file.
IW Starts/pauses playback.
Radio
FM+ / AM− Selects the band.
S / T Searches for stations.*
IW Switches the seek mode.
42 ENGLISH
0 – 9 • Specifies preset number. (1-5)
• Specifies the frequency of the
station to receive to search for in
direct search.
DIRECT Enters direct search mode.
* The search method differs according to the selected seek mode.
USB
FM+ / AM− Selects a folder.
S T Selects a file.
/
IW
Starts/pauses playback.
Searching for station frequency directly
While listening to the radio, you can search for a
station frequency directly using the number buttons.
1
Press DIRECT to enter the search mode.
2
Press a number button to select the
desired station frequency.
• To confirm the selection, press
To exit the search mode: Press DIRECT.

Installation and Connection

Installation and Connection
This section is for the professional installer.
For safety's sake, leave wiring and mounting to
professionals. Consult the car audio dealer.
WARNINGS
• DO NOT connect the ignition wire (red) and the
battery wire (yellow) to the car chassis (ground), you
may cause a short circuit, that in turn may start a fire.
• DO NOT cut out the fuse from the ignition wire (red)
and the battery wire (yellow). The power supply must
be connected to the wires via the fuse.
• Always connect the ignition wire (red) and the
battery wire (yellow) to the power source running
through the fuse box.
CAUTIONS
• Install this unit in the console of your car.
• Do not touch the metal parts of this unit during and
shortly after the use of the unit. Metal parts such as
the heat sink and enclosure become hot.
• When parking at a low ceiling area, turn off the unit
to store the aerial. As when the unit is installed in the
S / T .
car with the function of auto aerial; the radio aerial
extends automatically when you turn on the unit
with the aerial control wire (ANT. CONT) connected
(page 47).