Removing The Existing Belt Cover, Bracket, And Discharge Chute - Toro Z Master 4000 Series Operator's Manual

7
Removing the Existing
Belt Cover, Bracket, and
Discharge Chute
No Parts Required
Procedure
Note:
Clean the area around the belt cover before
removing it.
1. Lower the mower deck to the lowest height-of-cut
position.
2. Remove the right belt cover
Figure 17
3. Remove the right belt-cover bracket, 2 washers,
and 2 flange nuts from the mower deck
18).
Note:
Retain the hardware that you removed
during this procedure so that it is available for
changeover.
Figure 18
1. Right belt-cover bracket
2. Washers
(Figure 17).
g038092
(Figure
g038093
3. Flange nuts
4. Remove the locknut, bolt, spring, and spacer
holding the deflector to the pivot brackets
(Figure 19).
1. Bolt
2. Spacer
3. Locknut
4. Spring
5. Remove the grass deflector
Note:
Retain the hardware that you removed
during this procedure so that it is available for
changeover.
18
Figure 19
5. Spring installed
6. Grass deflector
7. J-hook end of spring
(Figure 19).
g015594