Installing The Bagger Supports And Brackets - Toro Z Master 4000 Series Operator's Manual

4
Installing the Bagger
Supports and Brackets
Parts needed for this procedure:
1 Upper bagger support
1 Support plate
1 Pivot mount
1 Left upper bracket
1 Right upper bracket
4 Hex-head bolt (5/16 x 3-1/4 inches)
4 Washer
2 Flange-head bolt (5/16 x 1-1/4 inches)
2 Hex-head bolt (3/8 x 1-1/4 inches)
2 Locknut (3/8 inch)
6 Locknut (5/16 inch)
Procedure
1. Secure the upper bagger support and support
plate to the center, rear guard using 2
flange-head bolts (5/16 x 1-1/4 inches) and 2
locknuts (5/16 inch) as shown in
1. Locknut (5/16 inch)
2. Support plate
Figure
Figure 11
3. Upper bagger support
4. Flange-head bolt (5/16 x
1-1/4 inches)
2. Remove the 2 torx-head bolts and 2 nuts from
the left, rear guard
Note:
machine, then the other.
1. Left, rear guard
2. Nut
11.
g375853
14
(Figure 12).
Perform the step above on 1 side of the
Figure 12
3. Torx-head bolt
g341515