Toro Z Master 4000 Series Operator's Manual page 16

Figure 14
Left side shown
1. Carriage bolt (5/16 x 2-1/4
inches)
2. Backer plate
3. Carriage bolt (3/8 x 7/8
inch)
3. Position the hopper assembly on its back.
4. Slide the hooks onto the lower mounting bracket
(Figure 15).
5. Rotate the hopper assembly onto the lower
hopper mounting bracket
6. Align the hole in the hopper with the upper
mounting bracket.
7. Install the pin and secure it using the hairpin
cotter on both sides
4. Locknut (3/8 inch)
5. Locknut (5/16 inch)
6. Left lower support
(Figure 15).
(Figure 15).
g375897
16
Figure 15
g375929