Table of Contents
Advertisement
4. Return the bagger arm to upright position in one quick
motion. Make sure the bagger door fully engages into
the latch (Fig. 26).
Note: Make sure the bagger latch is fully engaged before
collecting grass.
2
1
Figure 26
1. Bagger lever
Holding the Bagger Door Open
Warning
Hands, fingers and arms can get pinched between
the back and front sections of the collector.
Keep people away from collector while
emptying it.
If working on the inside, use the holding pin to
hold the collector door open.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Open the bagger; refer to Opening the Bagger, page 15.
4. With the bagger open, pull out the holding pin and
insert into the hole in the hinge (Fig. 27).
m–5872
2. Latch lever
16
2
3
Figure 27
1. Holding pin
2. Hole in hinge
Clearing Obstructions From
the Bagger System
1. Empty the bagger.
2. Disengage the PTO and set the parking brake.
3. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
4. Remove the complete tube assembly from the bagger
and boot.
5. Remove the boot from the mower.
6. Using a stick or similar object, carefully remove and
clear the obstruction from the mower, upper tube,
middle tube, or boot assembly.
7. After you remove the obstruction, install the complete
bagger system and resume operation. Refer to Installing
the Discharge Tubes on page 14.
Removing the Discharge Tubes
Note: Remember to replace the L end of the spring when in
side discharge mode. Refer to Replacing the Grass
Deflector Spring on page 17.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Unlatch the middle tube from the boot and slide apart
(Fig. 24).
1
m–5876
3. Hinge
Advertisement
Table of Contents
