Table of Contents
Advertisement
3.
On the ProCore 864 only, you can adjust the
stop bolt on the center support to attain the
proper gap.
8
Installing the Tine Heads
and the Tines
No Parts Required
Procedure
A wide selection of tines and tine heads are available
for the aerator. Choose the tine type, size, and
spacings required for the job. Install the tine head
and tines per the Installation Instructions supplied
with each tine kit. Refer to
for the accessories.
Important:
Never operate the aerator without
the tine heads installed. The arms may move
excessively and damage the aerator frame.
9
Installing the Turf Guards
Parts needed for this procedure:
–
Turf guards (not included)
Procedure
A wide selection of turf guards are available for the
aerator. Use the appropriate turf guards for the
selected tine heads.
1.
Loosen the nuts securing the turf guard clamps
to the turf guard tool bar
Figure 21
and
Figure 22
(Figure
17).
1. Turf guard
2.
Slide the appropriate turf guard under the turf
guard clamp.
3.
Adjust the turf guards, left to right, to maintain
equal distance to the tines within each slot.
4.
Tighten the nuts securing the turf guard.
5.
Mount the remaining turf guards and secure the
turf guard clamps.
Important:
From the rear of the machine,
check that the tines line up with the center of
the gaps in the turf guards.
10
Securing the Hood Latches
(CE only)
Parts needed for this procedure:
1
CE Compliance Kit, Part No. 110-4693 (not included)
Procedure
Note:
The CE Completion Kit, Part No. 110-4693 is
required to complete this step.
1.
On the ProCore 864 model, install a lock bracket
over the left and right rear lower hood and upper
hood latches with a tap bolt (4 total); refer to
Figure
18.
14
Figure 17
2. Turf guard clamp
g007331
Advertisement
Table of Contents
