Advertisement
Installing the Belt
1.
Install the belt onto the pulleys as follows:
•
Loop the belt around the drive pulley and
then over the top of the idler pulley
13).
Figure 13
1. Drive pulley
2. Idler-pulley assembly
•
Start the belt on the driven pulley
14).
•
Use a deep-well socket (9/16-inch) to rotate
the brush assembly and guide the belt onto
the driven pulley
Figure 14
1. Belt
Important:
Ensure that the ribs on the belt
are properly seated in the grooves in each
pulley and that the belt is in the center of the
idler pulley.
(Figure
3. Belt
4. Driven pulley
(Figure
(Figure
14).
2. Deep-well socket
(9/16-inch)
2.
Push down on the idler pulley to ensure that the
idler-pulley assembly pivots freely.
Completing the Installation
1.
Check the pulley alignment of the belt; refer to
Checking the Pulley Alignment (page
2.
If the pulleys are aligned, continue with the
installation. If they are not; refer to
Pulley Alignment (page
3.
Align the belt cover with the mounting holes and
secure the cover with 4 bolts
Important:
damage to the cover may occur.
g038702
1. Metal cover
2. Plastic cover
4.
Tighten the nuts securing the brush-assembly
mounting brackets to the cutting-unit side plates.
5.
Lubricate the grease fittings on each of the
roller brush bearing housings with No. 2 lithium
grease
(Figure
Note:
Wipe off any excess grease, specifically
around the excluder seals.
g033206
7
Adjusting the
10).
(Figure
Do not overtighten the bolts, as
Figure 15
3. Screw (4)
4. Drainage hole on bottom
16).
Figure 16
10).
15).
g035578
g033209
Advertisement
