Master Station Installation; Master Unit - Linear m&s VMC1 Instructions Manual

Master Station Installation

Master Unit

Prepare area and follow these instructions for installation of the Master Unit:
1. Pull the CAT5 and all other cables through the wall mount.
2. Lay the master face down on the bubble wrap provided in the packaging.
3. Fit all the Blue Block connectors to the terminal headers on the rear of the master, grove side down.
4. Terminate all the remaining wiring as directed in the Master Terminations section.
5. If accessible, remove the screw that is temporarily holding the TE6D power supply in place. If this screw
is left in place, do not use this location to attach the Master Unit to the Mounting Bracket.
6. Fit the back housing into the wall and secure using the 6G x 1½" screws provided.
7. Hang the master front from the top of the back housing.
8. Push the bottom of the plastic front clipping it into the plastic back
CONNECTING POWER TO THE MASTER UNIT
The Master Station has a dedicated pair of terminals labelled "VDC IN" on the termination PCB for the
connection of the power supply. When using DC power supply, be sure the Positive lead of the power supply
connects to the 13.8V terminal and the Negative lead of the power supply connects to the 0V terminal.
Figure 1
Figure 2
Keep cable
Before connecting,
pairs twisted
Strip each wire back
to reduce hum
1/4 Inch Maximum
CAT-5 Cable
Strip cable jacket
back 2 inches
6