Saeco Royal OTC Operation And Maintenance Manual page 40

English
MENU ITEM
Off
On
Stand-by Settings
15 minutes
30 minutes
60 minutes
180 minutes
Off
ALARMS
Coffee grounds drawer full
alarm
Off
On
DESCALING
Off
On
QUICK CLEAN
STANDARD CLEAN
Exit
PRE-GRINDING
Off
On
Pre-brewing
Off
Low
High
Temperature
Range from -5 to +5
USER PW
40
Description
This way, the coffee boiler is constantly kept at the right dispensing temperature.
In this mode, the power consumption is higher because the machine is always ready for
use.
This way, when in off position, the coffee boiler is kept at a temperature lower than the
one required when dispensing a beverage.
This way, the machine saves energy but needs more time to start dispensing beverages.
The appliance is factory preset so that this setting is not enabled by default.
To set the time interval for the machine to go into stand-by mode after the last brewing.
The default time value is «after 30 minutes».
The currently active setting is inside a dotted rectangular box.
Once the set time has elapsed, the machine goes into stand-by mode.
Press any button to turn the machine back on.
After performing the function diagnostics and the warm-up phase, the machine is again
ready for use.
When this parameter is set to "OFF", the machine stays active.
It allows you to activate and deactivate some alarms.
This function allows you to enable/disable the dregs alarms, i.e. the warning on the drawer
with the already brewed coffee pods being full and its need to be emptied.
The currently active setting is inside a dotted rectangular box.
alarm disabled
alarm enabled
This function enables/disables the warning (no blocking) on the need to descale the
machine hydraulic circuit.
This alert is displayed by a special icon on the "Ready for use" screen (see page 57).
The currently active setting is inside a dotted rectangular box.
With this setting, the warning message is disabled.
With this setting, the warning message is enabled;
the message is displayed when the machine needs to be descaled.
This function allows you to enable/disable the "Quick Clean" alarm, i.e. the warning for the
Cappuccinatore quick clean cycle.
This function allows you to enable/disable the "Standard Clean" alarm, i.e. the warning for
the Cappuccinatore standard clean cycle.
This option allows the user to go back to the menu top level
This function enables/disables the pre-grinding prior the next coffee dose.
This way, upon selecting the beverage, the user will already have the coffee powder ready
for brewing and will save the grinding time.
The currently active setting is inside a dotted rectangular box.
With this setting, the pre-grinding function is disabled.
With this setting, the pre-grinding function is enabled;
This function adjusts the break time between pod pre-brewing and its actual dispensing.
The currently active setting is inside a dotted rectangular box.
It disables pre-brewing
It activates a short break between pre-brewing and dispensing (2 sec)
It activates a long break between pre-brewing and dispensing (4 sec)
This function allows you to adjust any increase/decrease in the coffee temperature inside
the cups
It allows to lower or increase the temperature of the product on a range between -5 and
+5.
This function allows you to set or disable the password to access the User menu.
NOTE:
Enter the value '0000' as password to disable the password.
If you forget the PASSWORD, you must start a reset procedure. Please contact Saeco
(Evoca group) customer service.