Hitachi SH1 Series Basic Manual page 39

Chapter 3
The frequency source and run command source are
necessary to drive the motor.
 Frequency source 1
3.3 Frequency setting from keypad
•
Select [AA101] = 07 Frequency source from parameter
setting screen.
•
Changing frequency setting from each source
(1) [FA-01] for frequency setting from keypad or
(2) [Ab110] for frequency setting at multispeed profile.
Eg.) For [FA-01]

 Frequency source
•
Change the frequency source setting [Ab110] to
"Multispeed-0 speed No.1" by using the up and down
arrow keys.
 Parameter
Parameter
Frequency source setting
[AA101]
from keypad
[FA-01]*) Main speed command
[Ab110]*) Multispeed-0 speed No. 1
*) While [AA101] = 07, a change made in either [FA-01]
or [Ab110] will be automatically reflected in the
other. When no change can be made or is reflected
in [FA-01], the operator keypad is not specified as a
command source by the terminal function or
[AA101].
You need to set the frequency value to a value other
than 0.00.
Setting
Details
data
07
0.00Hz
0.00Hz
Operation Setting and Examples of I/O Adjustment
 Run command source 1
3.4 Run using the operator keypad
•
Select [AA111] = 02 on the parameter setting screen to
RUN from keypad.

 Run/stop command
Press the RUN key and STOP key on the operator
keypad to start and stop the inverter, respectively.
 Parameter
Parameter
[AA111]
3-2
Details Setting data
Run by pressing the
RUN key of keypad.
02