Connection J1 Remote I/O Interconnections - Agilent Technologies TwisTorr Medium-TMP Rack User Manual

Technical Information

Connection J1 Remote I/O Interconnections

Figure 31 Remote I/O connector
All the input/output remote signals to/from the controller must be connected at P1
mating connector. With the provided J1 mating connector (shipped with pin 3
shorted with pin 9 and pin 4 shorted with pin 15) make the connection with AWG 24
(0.25 mm
capability. It is a 15-pins D type connector; the available signals are detailed in the
table, the following paragraphs describe the signal characteristics and use.
Table 9
Pin N.
1
2
3
4
5
6
7
8
9
10
11
152
2
) or smaller wire to the pins indicated in the figure to obtain the desired
Signal characteristics and use
Signal Name
Start/Stop (+)
Start/Stop (-)
Interlock (+)
Interlock (-)
Speed setting (+)
Speed setting (-)
Soft start (+)
Soft start (-)
+ 24 vdc
SET POINT (RELAY)
Programmable set point (open collector)
Agilent TwisTorr Medium-TMP Rack Controller User Manual
IN-/OUTPUT
In
In
In
In
In
In
In
In
Out
Out
Out