47 Cfr Part 15 Regulation; Fax Branding Statement - Multitech MA100-1M User Manual

12. Manufacturing Information:
Manufacturer:
Trade Name:
Model Number:
Registration No:
Ringer Equivalence:
Modular Jack (USOC):
Service Center in USA:

47 CFR Part 15 Regulation

This equipment has been tested and found to comply with the limits for a Class B digital Device, pursuant
to 47 CFR Part 15 regulations. The stated limits in this regulation are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Plug the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This Device complies with Part 15 of the CFR 47 rules. Operation of this Device is subject to the following
conditions:
(1) This Device may not cause harmful interference, and (2) this Device must accept any interference that
may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.

Fax Branding Statement

The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or
other electronic Device, including fax machines, to send any message unless such message clearly
contains the following information:
•
Date and time the message is sent
•
Identification of the business or other entity, or other individual sending the message
•
Telephone number of the sending machine or such business, other entity, or individual
This information is to appear in a margin at the top or bottom of each transmitted page or on the first page
of the transmission. (Adding this information in the margin is referred to as fax branding).
Any number of fax software packages can be used with this product. Refer to the fax software manual for
setup details. Typically, the fax branding information must be entered via the configuration menu of the
software.
Multi-Tech Systems, Inc. MultiAccess ACS User Guide
Multi-Tech Systems, Inc.
MultiAccess ACS
MA100-1M
AU7USA-25814-M5-E
0.3B
RJ11C or RJ11W (single line)
Multi-Tech Systems, Inc.
2205 Woodale Drive
Mounds View, MN 55112 U.S.A.
(763) 785-3500
(763) 785-9874 Fax
Appendix B – Regulatory Information
41