Step 6: Verify The Setup Configuration - Multitech ProxyServer MTPSR1-100 User Manual

Chapter 2 - ProxyServer Wizard
Note: ISDN TA Setup
!!! Extremely Important !!!
TA
If you do not see your ISDN TA listed, you need to enter the initial string for this TA in
ProxyServer Manager's Modem Settings menu. Once you have finished ProxyServer
Wizard press the Run Manager button and refer to Chapter 3 - ProxyServer Manager :
Modem Settings for instructions.
Baudrate
In the Baudrate field select the DTE Speed (i.e., the speed of communication between
the ProxyServer and modem or ISDN TA) Normally this can be about 4 times the speed
of your modem for 4 times compression modems.
Note: The absolute maximum you should set the baudrate for a given port on your
ProxyServer is 4 times the speed of your modem. If you set the baudrate too high, the
ProxyServer may not be able to dial-up a connection. For example if you have a 14.4K
bps modem, the highest you should set the baudrate is 57.6K bps. Also note that due to
ISP connections and phone line conditions this maximum speed is theoretical and not
guaranteed.
When you are finished, click Next to continue.

Step 6: Verify the Setup Configuration

The settings that you have just configured will be summarized here. Please check to
make sure that all the settings you have entered are correct.
If you see that you have configured a setting incorrectly, click Back to go back to the
screen with the mistake and correct it.
When you are satisfied with your configuration, click Finish to save your configuration to
the ProxyServer and complete the ProxyServer Wizard.
11