Siemens MAGNETOM Avanto Operator's Manual page 73

Set the upper volume limit for
automatic voice
Start automatic voice output
Connecting the audio
equipment
MAGNETOM Avanto, MAGNETOM Verio | syngo MR E11
Print No. MR-01501G.621.02.02.02
MR system components
Music and automatic voice output are interrupted.
3 Speak into the microphone from a distance of approx. 30 to 40 cm.
The patient can hear the announcement via the headphones and
the speaker.
4 Release the button to end the transmission.
The upper volume limit is set via software. Set once, the upper limit is
not changed for every examination; it is changed as per requirement.
✓ The Play music button is switched off, the Music on LED is off.
1 Set the CV/CBT switch to CV.
2 Set the volume control Patient instructions to max. volume at the
control unit.
3 Use the software to initiate automatic voice output, see:
operator manual.
4 Increase the volume in the software to a level until you reach the
desired upper limit volume in the examination room.
5 Decrease the final volume of the headset and loudspeaker to the
desired level using the volume regulator Patient instructions at
the operating unit of the intercom.
✓ The upper volume limit is set.
✓
The Play music button is switched off, the Music on LED is off.
1 Set the CV/CBT switch to CV.
2 Use the software to initiate automatic voice output, see:
operator manual.
3 Set the desired volume at the headset and loudspeaker using the
volume regulator Patient instructions at the control unit.
To play music in the examination room, an analog audio source is
connected to the central unit of the intercom.
The connections for audio equipment are located at the central unit
of the intercom in back of the syngo Acquisition Workplace.
3
Software
Software
73