Registration; Advanced Settings; Set The Dial Mode; Set The Flash Time - Motorola L401 User Manual
Dect 6.0 cordless phones with answering system
Hide thumbs
Also See for L401:
- User manual (38 pages) ,
- Quick start manual (8 pages) ,
- Quick start manual (8 pages)
Table of Contents
Advertisement
6.7
Registration
Up to 5 handsets can be registered to one base. The original
handset is pre-registered to use. Additional handsets must
be registered to the base before you can use them.
To register an additional handset,
P
,
1. Press
and
to select
P
,
2. Press
and
to select
P
,
3. Press
and
to select
P
YES
4. Select
and press
procedure as below:
1. Place the unregistered cordless handset on the
charger.
v
2. Press and hold
for 4 seconds on base.
v
3. Release
once IN USE LED is flashing.
4. A confirmation tone is generated if registration is
HANDSET X
successful.
the number of handsets and the phone goes back to
idle.
28
SETUP HS
.
REGISTRATION
.
YES
NO
or
.
to enter the registration
X
is displayed where
denotes
7. Advanced Settings
7.1
Set the Dial Mode
The default dialing mode is suitable for your country and
network operator. It is unlikely that you should need to
change this setting unless advised to do so.
P
,
1. Press
and
to select
P
DIAL MODE
2. Press
to select
P
,
3. Press
and
to select
P
4. Press
to save.
NOTE
If pulse mode is selected, press
tone dialing temporarily when dialing out. After the call is
ended, the dial mode will change back to pulse.
7.2
Set the Flash Time
The default flash time is 600MS. It is unlikely that you should
need to change this setting unless advised to do so.
P
,
1. Press
and
to select
P
,
2. Press
and
to select
SETUP BS
.
.
TONE
PULSE
or
.
*
to switch from pulse to
SETUP BS
.
FLASH TIME
.
Advanced Settings
Advertisement
Table of Contents
