Setting The Dial Mode; Setting The Flash Time; Setting The Area Code; Registration - Motorola L803 User Manual

Doc Title : Product Data - User Manual
Model : Motorola L80x

3.15 Setting the dial mode

The default dialing mode is suitable for your country and network operator. It is unlikely that you should need to
change this setting unless advised to do so.
1. Press MENU / SELECT and then UP or DOWN to select SETUP BS.
2. Press MENU / SELECT to select DAIL MODE.
3. Press MENU / SELECT and then UP or DOWN to select TONE or PULSE.
4. Press MENU / SELECT to save.
NOTE
If the pulse mode is selected, press TONE/* to switch from pulse to tone dialing temporarily when dialing out. After
the call is ended, the dial mode will change back to pulse.

3.16 Setting the flash time

The default flash time is 600MS. It is unlikely that you should need to change this setting unless advised to do so.
1. Press MENU/SELECT and then UP or DOWN to select SETUP BS.
2. Press MENU/SELECT and then UP or DOWN to select FLASH TIME.
3. Press MENU/SELECT and then UP or DOWN to the flash time you want. ( 8 options are available : 90, 100,
110, 250, 300, 400, 600 and 700MS)
4. Press MENU / SELECT to save.

3.17 Setting the area code

1. Press MENU/SELECT and then UP or DOWN to select SETUP BS.
2. Press MENU/SELECT and then UP or DOWN to select AREA CODE.
3. Press MENU/SELECT and then enter the area code.
4. Press MENU/SLECT to save.

3.18 Registration

Up to 5 handsets can be registered to one base. The original handset is pre-registered to use.
Additional handsets must be registered to the base before you can use them.
To register an additional handset,
1. Press MENU /SELECT and then UP or DOWN to select SETUP HS.
2. Press MENU /SELECT and then UP or DOWN to select REGISTRATION.
3. Press MENU /SELECT and then UP or DOWN to select YES or NO.
4. Select YES then press MENU/SELECT to enter the registration procedure as follows:
1. Press and hold FIND for around 4 seconds on the base.
2. Place the unregistered cordless handset on the base or charger.
3. A confirmation tone is generated if registration is successful. HANDSETX is displayed where X denotes
the number of handsets, and then the phone returns to idle.
To register an originally unregistered handset, follow steps 1 through 3 above.

3.19 Resetting all settings

1. Press MENU/SELECT and then UP or DOWN to select RESET SETTINGS.
2. Press MENU/SELECT and then UP or DOWN to select ALL SETTINGS.
3. Press MENU/SELECT and to select YES. All personalized settings will reset to default.
NOTE
All of your phonebook entries, calls list, and redial list, will remained unchanged.

3.20 Paging / Finding a handset

Press FIND on the base. All handsets registered to the base will ring or beep.
To stop the paging, press FIND again, or press any key on the handset, or place the handset on the base.

3.21 Using your answering machine

3.21.1 Playing messages

1. Press PLAY / STOP on the handset from idle mode. New messages will be played followed by any older
messages.
2. During the message playback, press the keys below on the handset to perform the following functions:
PLAY / STOP Press to playback or stop playing messages
SKIP FORWARD
This document contains confidential and proprietary information of VTech Telecommunications Ltd
Skip to play the next message
Revision :
Page(s) :
R.00
16 of 27