Voltage/Current Test (Voc /Isc ) - Fluke SMFT-1000 User Manual

Voltage/Current Test (V
The V is a test to IEC 62446-1 Clause 6.4 for the maximum voltage that the solar panel
OC
produces in standard test conditions. The I
maximum current that the solar panel produces in standard test conditions.
To test:
1. Install the Irradiance Meter at the solar panel to test.
2. Turn the rotary switch on the PV Analyzer to the V
3. Set the limit for V
STC calculation limits: calculated from irradiance and nominal values.
4. Set the limit for I
STC calculation limits: calculated from irradiance and nominal values.
Irr & Tcell data from the Irradiance Meter shows on the display.
5. Connect the red test lead to positive connector of string and the blue test lead to negative
connector of string.
Tip: Push
The V
OC
If the PV Analyzer detects reverse polarity, you will hear an audible beep and the
display shows a warning for a failed test due to a negative measurement.
6. Push 
The V
OC
Irradiance Meter.
7. Push 
A confirmation message with ID number shows on the display and then returns to the test
screen.
Find Quality Products Online at:
OC
based on data from Irradiance Meter and PV model.
OC
based on data from Irradiance Meter and PV model.
SC
 to see a connection diagram.
measurement shows on the display after you connect the test leads.
to start the I measurement.
SC
and I results show on the display with a Pass/Fail icon based on the limit from the
SC
to save the results to memory.
GlobalTestSupply
www.
/I )
SC
is a test to IEC 62446-1 Clause 6.5.2 for the
SC
/I
OC SC
Note
Multifunction PV Analyzer
position.
.com
sales@GlobalTestSupply.com
Test Setup
21