Table of Contents
Advertisement
MAINTENANCE
CHECK BATTERY CONNECTIONS
Improper handling of high voltage wiring, batteries or control systems could
result in serious injury or death by electric shock. Only qualified technicians
should repair or access high voltage wiring, battery packs and associated
Inspect and clean battery terminal connections monthly. Carefully remove
corrosion with a stiff wire brush. Coat battery terminals with dielectric grease or
petroleum jelly. Using an insulated wrench, torque bolts to 8 lb-ft (10.8 Nm).
CHECK BATTERY CABLES AND WIRING
Check the battery compartment for any signs of worn insulation, frayed cables or
damaged cable ends. If found, see your authorized GEM dealer or other
qualified service person for service before operating.
If battery cable ends are damaged or corroded, they should be replaced or
cleaned as necessary. Failure to do so may cause them to overheat during
operation, possibly leading to fire, which may result in serious injury or death
CHECK BATTERY HOLD-DOWN BARS
Battery hold-down bars should be snug to keep batteries from moving while the
vehicle is in motion, but not so tight as to crack or buckle the battery case.
Torque fasteners to 9.5 lb-ft (13 Nm).
BATTERY REPLACEMENT
With proper care and maintenance, as outlined in this owner's manual, battery
life can be maximized, but the battery will eventually reach the end of its useful
life. When battery replacement is necessary, your authorized GEM dealer can
provide this service.
Always install batteries of the exact type and make originally supplied with the
vehicle to prevent damage to the vehicle's electrical system.
Handling batteries and electrical components improperly can result in serious
injury or death. Do not attempt to remove batteries or battery cables. Battery
posts are identified on the battery case as positive (+) and negative (-). Your
authorized GEM dealer can provide battery-related service
72
WARNING
systems.
WARNING
NOTICE
WARNING
Advertisement
Chapters
Table of Contents
