Battery Handling Precautions - GEM e2 2019 Owner's Manual

FEATURES AND CONTROLS
It is not necessary to remove or disconnect battery post connections during the

BATTERY HANDLING PRECAUTIONS

Do not work in or near the battery compartment or on any other electrical
component of the vehicle while charging the batteries.
Before servicing the vehicle's electrical system, always disconnect the main
power connector first, then disconnect any electrical accessory connections,
then disconnect the negative cable from the 12-volt battery (if equipped), then
disconnect the negative terminal from the main battery pack. See page 32.
This will disable the vehicle by disconnecting the battery pack from the motor. It
does not disable the battery pack. HIGH VOLTAGE will be present at the
HIGH BATTERY VOLTAGE IS ALWAYS PRESENT. DO NOT TOUCH THE
• Always make sure that all 12-volt electrical accessories are grounded directly
to the negative (-) post on the terminal board. Never use the chassis or body
as a ground connection. See page 41.
• Make sure vent caps are installed properly and securely during vehicle
operation and battery charging.
• Never connect a 12–volt accessory directly to the batteries. Always connect
any powered accessory to the 12–volt terminal board. See page 41.
• Never connect jumper cables to any of the batteries of this vehicle.
• Always wear safety glasses or approved eye protection when servicing the
vehicle. Wear a full-face shield and gloves when working with or around
batteries and electrical connectors.
• Use only insulated tools when working in the battery compartment.
• Always keep battery terminals and connections clean and free of corrosion at
all times. See page 71 and page 75.
40
TIP
alternate charging method.
WARNING
battery terminals and contactor.
BATTERY TERMINALS.