Toro 140-5800 Installation Instructions Manual page 8

1. Kit wire harness
2. Front of the machine
Installing the Coil and Valve to the
Traction Manifold
1. Remove the relief-valve cartridge from port RV1
of the traction manifold
Note:
Loosen the relief-valve cartridge using
the hex flats of the valve body.
Figure 14
3. Traction manifold
(Figure 15).
g321582
g321567
1. Port RV1 (traction
manifold)
2. Front of the machine
3. Relief-valve cartridge
2. Install the traction-control valve into port RV1 of
the traction manifold
Important:
flats of the valve body.
3. Assemble the coil onto the traction-control valve,
and secure the coil with the coil nut
4. Torque the coil nut to 9.5 to 13.6 N∙m (84 to 120
in-lb).
Connecting the Kit Wire Harness
to the Traction Manifold
1. Remove the 2-socket connector of the machine
wire harness labeled
from the 2-pin connector of the solenoid valve in
port SV of the traction manifold
8
Figure 15
4. Traction-control valve
5. Coil
6. Coil nut
(Figure 15).
Tighten the valve using the hex
TRACTION MOW
(Figure
g321606
(Figure 15).
/
TRANSPORT
16).