Toro 140-5800 Installation Instructions Manual page 3

2
Installing the Momentary
Switch
Parts needed for this procedure:
1 Momentary switch
1 Washer (5/8 inch)
1
Jam nut (5/8 inch)
1 Decal
1 Wire Harness
Preparing the Control Console
1. At the outboard side of the control console,
remove the 5 flange-head capscrews that secure
the right control-console cover
1. Control console panel
2. Flange-head capscrew
2. Move the operator's seat rearward.
3. Measure 289 mm (11-3/8 inches) from the back
of the of the console arm, and mark the surface
of the left console panel
(Figure 2).
Figure 2
3. Control-console cover
(right)
(Figure 3).
4. Measure 25 mm (1 inch) from the top of the of
the console arm, and mark the surface of the left
console panel
5. At the intersection of the marks, center-punch
the left console panel.
6. Drill a hole—17 mm (21/32 inch) at the
center-punch mark
Important:
g320588
console panel.
Assembling the Momentary Switch
to the Control Console
1. Assemble the momentary switch into the hole
left console panel
3
Figure 3
(Figure 3).
(Figure 3).
Use caution when drilling the
(Figure 4).
g320614