Rep 12.8 Jogger Belts - Xerox WorkCentre 4150 Service Manual

7. If necessary, remove the Ejector Motor
3
Remove two screws
marked B.
4
Remove the Ejector Motor.
Figure 4 Removing the Ejector Motor
Replacement
Replacement is the reverse of the removal procedure.
NOTE: Ensure that the front Support Finger and rear Support Finger are aligned correctly.
WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
(Figure 4).
2
Remove the Ejector
Motor assembly.
1
Remove three screws
marked A.

REP 12.8 Jogger Belts

Parts List on PL 12.30
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions,
1. Remove the particular Jogger Assembly,
2. Remove the motor spring,
3. Remove the Jogger Motor,
19 as a unit from the Jogger Assembly.
4. Release the Jogger Belt from the Belt Holder,
5. Remove the Jogger Belt, PL 12.30 Item
Replacement
Replacement is the reverse of the removal procedure. Ensure that the Jogger Belt has been
tensioned correctly before the Jogger Motor securing screws are tightened.
January 2016
4-177
WARNING
WARNING
CAUTION
REP 12.5.
PL 12.30 Item 18.
PL 12.30 Item 20 and the Jogger Motor bracket,
PL 12.30 Item 22.
23.
Repairs and Adjustments
REP 12.7, REP 12.8
GP 10.
PL 12.30 Item