Xerox WorkCentre 4150 Service Manual page 361

Replacement
Do not damage the fuser stripper fingers when reinstalling the heat roller assembly, refer to
Figure 4.
1. Reinstallation is the reverse of the Removal procedure.
2. Position the spring on the Front Jam Lever in the slot on the Fuser frame
Figure 7 Positioning the Front Jam Lever Spring on the Fuser Frame
3. If a new heat roller assembly or pressure roller are installed, reset the HFSI count to zero.
Go to GP 16 High Frequency Service Items.
Repairs and Adjustments
REP 10.7
CAUTION
(Figure
1
Position the spring on the
slot in the Fuser frame.
7).
January 2016
4-160 WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/