Advertisement
Figure 20
1. Negative battery cable
2. Slot (battery tray)
3.
Apply a thin coat of battery terminal protector to
the battery-cable clamp.
4.
Assemble the battery cover over the battery,
aligning the tabs of the cover into the slots in the
battery tray
(Figure
Purging Air from the Fuel System
1.
Rotate the ignition key to the R
2.
Allow the electric fuel pump to run for 10
seconds.
3.
Rotate the ignition key to the S
4.
Wait for 35 to 40 seconds.
5.
Repeat steps
1
through
6.
Start the engine, and preform the steps in
Checking for Fuel Leaks (page
Checking for Fuel Leaks
1.
Check the fuel hoses, fittings, and fuel cooler
for leaks.
Important:
Repair all fuel leaks.
2.
Shut off the engine and remove the key.
3. Battery cover
20).
or O
position.
UN
N
position.
TOP
4
again 2 more times.
10).
Installing the Screen
1.
Assemble the hinge of the screen onto the pivot
pins if the radiator frame
g356366
1. Hinge (screen)
2. Pivot pin (radiator frame)
2.
Close the screen and secure it to the radiator
frame with the latch
3.
Insert the ball pin through the holes in the latch
(Figure
21).
10
(Figure
21).
Figure 21
3. Ball pin
4. Latch
(Figure
21).
g356361
Advertisement
