Toro 139-6040 Installation Instructions Manual page 4

Figure 6
1. Push-in cable ties/anchors
6. Remove the adhesive backing from the 4 foam
strips (Figure 7).
Figure 7
1. Foam strip—vertical 12.7
x 12.7 x 127 mm (1/2 x 1/2
x 5 inches)
2. Fuel-cooler bracket
7. At the other side of the fuel-cooler bracket, apply
to vertical and horizontal foam strips as shown
in Figure 7.
g356312
g356295
3. Foam strip—horizontal
12.7 x 12.7 x 152 mm (1/2
x 1/2 x 6 inches)
5
Installing the Fuel Cooler to
the Radiator Bracket
Parts needed for this procedure:
1 Grommet
2 Capscrew (5/16 x 5/8 inch)
Machines with a Radiator Bracket
Knock-Out Plug
1. At the left side of the battery tray, remove the
knock-out plug from the radiator bracket
8).
1. Knock-out plug (radiator bracket)
2. Remove all burrs from the hole in the bracket.
4
Figure 8
(Figure
g356308