Pro-Form 600 LT User Manual page 12

12. With the help of a second person, hold the con-
sole assembly near the Right Handrail (85).
Connect the Upright Wire (88) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. Remove the wire tie from the
Upright Wire.
13. Set the console assembly on the Left Handrail
(84) and the Right Handrail (85). Be careful not
to pinch any wires. Insert the excess Upright
Wire (not shown) into the Right Handrail.
Attach the console assembly with six #8 x 1/2"
Screws (16), four 1/4" x 1/2" Bolts (3), four 5/16"
Flat Washers (108), and four 5/16" Star
Washers (13) as shown. Start all six Screws
and all four Bolts, and then tighten each of
them.
See step 9. Fully tighten the four 5/16" x 1"
Bolts (5) and the two 5/16" x 1 1/4" Bolts (2).
All manuals and user guides at all-guides.com
12
12
Console
Assembly
85
13
85
13
108
3
16
16
Console
Wire
88
Console
Wire
Wire
Tie
88
Console
Assembly
13
108
3
16
16
84